Henderson Taper-Lock Cutting Head

Description

NOTE: CUTTER HEADS CAN NOW BE ORDERED FACTORY ADJUSTED AND NON-ADJUSTED

The Taper-Lock cutter head utilizes both the Forster pilots and carbide blades.  The Taper-Lock cutter head trims full length as well as chamfers both the inside and outside of the case.  The carbide blades are extremely repeatable and bullet proof.

These will only fit the Gen 3 trimmer with the Taper-Lock shaft
Not for the Gen 2 Trimmer

Cutter bodies are machined from 416 stainless steel Chamfers the inside case mouth to an angle of 14°. Chamfers the outside case mouth to an angle of 30°Blades are made from carbide. The Taper-Lock cutters are factory adjusted and tested for each caliber. Utilizes a through shaft screw design for precision alignment All pilots are Caliber-Specific.
Taper-Lock Cutter Replacement
Disconnect Power Source Before making Any Adjustment
Refer to pictures above
Insert 5/32 Allen wrench into socket head screw in the middle of the pulley
Insert 11/16 wrench on the front of drive shaft
Holding the Allen wrench fixed, loosen the cutter with the 11/16 wrench
Once loose, remove socket head screw with fingers
Replace cutter making sure both tapers are clean
Hold cutter firm against the female taper with fingers reinsert the 10/24 socket head screw until both parts are snug
Inserted the 10/24 Allen wrench holding it fixed tight cutter to the shaft with 11/16 wrench until snug.
Do not over tighten assembly